Table of Contents
Advertisement
1
Figure 3
1. Expansion tank
3. If the coolant is low, add a 50/50 mixture of water and
ethylene glycol anti-freeze. Do not use water only or
alcohol/methanol base coolants.
4. Install the radiator cap and expansion tank cap.
Filling the Fuel Tank
The capacity of the fuel tank is 19 gallons (72 l).
1. Remove the fuel tank cap (Fig. 4).
2. Fill the tank to about 1 inch (25 mm) below the top of
the tank, not the filler neck, with No. 2 diesel fuel. Then
install the cap.
1
Figure 4
1. Fuel tank cap
Danger
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A fire
or explosion from fuel can burn you and others
and can cause property damage.
• Use a funnel and fill the fuel tank outdoors, in
an open area, when the engine is off and is cold.
Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add fuel
to the fuel tank until the level is 1 in. (25 mm)
below the bottom of the filler neck. This empty
space in the tank allows the fuel to expand.
• Never smoke when handling fuel, and stay away
from an open flame or where fuel fumes may be
ignited by a spark.
• Store fuel in a clean, safety-approved container
and keep the cap in place.
Checking the Hydraulic Fluid
The machines reservoir is filled at the factory with
approximately 8 U.S. gallons (30 l) of high quality
hydraulic fluid. Check the level of the hydraulic fluid
before the engine is first started and daily thereafter.
The recommended replacement fluid is:
Toro Premium All Season Hydraulic Fluid
(Available in 5 gallon pails or 55 gallon drums. See
parts catalog or Toro distributor for part numbers.)
Alternate fluids: If the Toro fluid is not available, other
fluids may be used provided they meet all the following
material properties and industry specifications. We do not
recommend the use of synthetic fluid. Consult with your
lubricant distributor to identify a satisfactory product Note:
Toro will not assume responsibility for damage caused by
improper substitutions, so use only products from reputable
manufacturers who will stand behind their
recommendation.
High Viscosity Index/Low Pour Point Antiwear
Hydraulic Fluid, ISO VG 46
Material Properties:
Viscosity, ASTM D445
Viscosity Index ASTM D2270 140 to 160
Pour Point, ASTM D97
Industry Specifications:
Vickers I–286–S (Quality Level), Vickers M–2950–S
(Quality Level), Denison HF–0
16
cSt @ 40_ C 44 to 48
cSt @ 100_ C 7.9 to 8.5
–34_ F to –49_ F
Advertisement
Table of Contents
