Table of Contents
Advertisement
Figure 23
1. Front castor arm
2. Castor fork
1
3
2
3. Shims
23
Matching Height Of Cut Between Outside
Edges of Cutting Units
1. Position blade side to side on outside spindle of both
wing cutting units. Measure from the floor to the tip of
the cutting edge on both units and compare. These
numbers should be within 1/8 in. (3 mm) of each other.
2. Add or remove 1/8" shims as needed on wing castor
wheels. Recheck measurement between outside edges
of both wing cutting units and adjust as necessary.
Advertisement
Table of Contents
