Operating the Parking Brake
Always set the parking brake when you stop the machine or
leave it unattended.
Setting the Parking Brake
1. Move the motion control levers (Figure 18) out to the
neutral locked position.
2. Pull up and back on the parking brake lever to set the
parking brake (Figure 14). The parking brake lever
should stay firmly in the engaged position.
1. Parking brake lever
WARNING
The parking brake may not hold the machine
parked on a slope and could cause personal
injury or property damage.
Do not park on slopes unless the wheels are
chocked or blocked
Releasing the Parking Brake
Push forward and down on the parking brake lever to release
the parking brake (Figure 14).
Figure 14
Starting and Stopping the
Engine
Starting the Engine
1. Raise the roll bar up and lock it into place, sit on the
seat, and fasten the seat belt.
2. Ensure that the motion controls are in the neutral
locked position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the PTO (power take off) switch to the off
position (Figure 16).
1. Ignition switch
2. Throttle control
5. Move the throttle lever midway between the Fast and
Slow positions (Figure 16).
6. Turn the ignition key clockwise to the Run position
(Figure 17).
21
Figure 15
Figure 16
3. Glow plug light
4. Power take off switch
(PTO)