Starting And Stopping The Engine - Toro Z Master 74925TE Operator's Manual

Starting and Stopping the
Engine
Starting the Engine
1. Raise the ROPS up and lock into place, sit on the
seat and fasten the seat belt.
2. Move the motion controls to neutral locked
position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the blade control switch (PTO) to the Off
position (Figure 19).
5. Move the throttle lever midway between the Slow
and Fast positions.
Figure 19
6. Turn the ignition key to the Start position
(Figure 17). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
1. Off
2. Run
Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Let the engine idle at slow throttle (turtle) for 60
seconds before turning the ignition switch off.
g017006
21
G008947
Figure 20
3. Start