Using The Z Stand - Toro Z Master 74925TE Operator's Manual

Figure 38
1. Trailer
2. Full width ramp
Using the Z Stand®
The Z Stand® raises the front end of the machine to
allow you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and cause
serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand®.
• Use only for cleaning the mower and removing
the blades.
• Do not keep the machine on the Z Stand for
extended periods of time.
• Always turn the engine off, set the parking
brake, and remove the key before performing
any maintenance to the mower.
Driving up onto the Z Stand
Important: Use the Z Stand on a level surface.
1. Raise the mower to the transport position.
2. Remove the bracket pin (Figure 39).
3. Not greater than
15 degrees
4. Full width ramp—side view
1. Z Stand
2. Bracket Pin
3. Bracket
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(Figure 39 and Figure 40).
1. Z Stand (Positioned in
slot)
2. Crack in side walk or turf
4. Set the foot of stand on the ground and rest the
latch on the pivot tab (Figure 40).
5. Start the engine and put it at half throttle.
Note: For best results, place the foot of stand into
seams in sidewalks or into the turf (Figure 40).
6. Drive onto the stand. Stop when the latch drops
over the tab into the locked position (Figure 40).
Once onto the stand, engage the parking brake and
tun off the engine.
7. Chock or block the drive wheels.
30
Figure 39
4. Bottom of slot
5. Latch
Figure 40
3. Latch resting on pivot tab