Specifications - Toro Z Master 74925TE Operator's Manual

Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the
electric clutch and drive the mower blades. Pull the
switch up to engage the blades and release. To disengage
the blades, push the blade control switch (PTO) down
or move a motion control lever into the neutral lock
position.
Ignition Switch
This switch is used to start the mower engine and has
three positions: Start, Run and Off.
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system and to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (under the seat) when
transporting or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.

Specifications

Note: Specifications and design are subject to change
without notice.
Width:
Without Deck
Deflector Up
Deflector Down
Length:
Roll Bar - Up
Roll Bar - Down
60 inch Deck
53.0 inches (134.6 cm)
61.7 inches (156.8 cm)
75.7 inches (192.2 cm)
60 inch Deck
83.1 inches (211.1 cm)
84.8 inches (215.4 cm)
Height:
Roll Bar - Up
70.5 inches (179.1 cm)
Weight:
Model
74925TE
15
Roll Bar - Down
46.8 inches (118.9 cm)
Weight
1301lb (590 kg)