Toro 03206 Operator's Manual page 19

1
Figure 22
1. Stop bolt
2. Lift arm
Note: If rear lift arm "clunks" during transport, clearance
can be reduced.
2. Check to make sure clearance between each lift arm and
stop bolt is .005" – .040" (Fig. 22). If clearance is not in
this range, adjust stop bolts to attain clearance.
3. Start engine, raise lift arms and check to make sure
clearance between wear strap on top of rear cutting unit
wear bar and bumper strap is .020" – .100" (Fig. 23). If
clearance is not in this range, adjust rear cylinder to
attain clearance. To adjust cylinder, lower the cutting
units and back off the jam nut on the cylinder (Fig. 24).
Grasp cylinder rod close to the nut with a pliers and rag
and rotate the rod. Raise the cutting units and check
clearance. Repeat procedure if required. Tighten clevis
jam nut.
1
Figure 23
1. Wear bar
3
2
3. Clearance
2
2. Bumper strap
19
1
Figure 24
1. Rear cylinder
Important Lack of clearance at front stops or rear
wear bar could damage lift arms.
2
2. Adjusting nut