Toro 30607 Operator's Manual page 20

InfoCenter Icon Description (cont'd.)
Denied or not allowed
Engine Start
PTO-indicates the PTO is On
Stop or shutdown
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
Hydraulic Oil Temperature-indicates
the hydraulic oil temperature
CAN bus
InfoCenter
Bad or failed
Center
Right
Left
Bulb
Output of TEC controller or control
wire in harness
High: over allowed range
Low: under allowed range
Out of range
/
Switch
Operator must release switch
Operator should change to indicated
state
InfoCenter Icon Description (cont'd.)
Symbols are often
combined to form
sentences. Some
examples are shown
below
Using the Menus
To access the InfoCenter menu system, press the menu access
button while at the main screen. This will bring you to the
main menu. Refer to the following tables for a synopsis of
the options available from the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
20
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
Hydraulic oil too hot
Sit down or set parking brake
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your Authorized Toro
Distributor for more information
on the Faults menu and the
information contained there.
The Service menu contains
information on the machine
such as hours of use and other
similar numbers.
The Diagnostics menu displays
the state of each machine
switch, sensor and control
output. You can use this to
troubleshoot certain issues as
it will quickly tell you which
machine controls are on and
which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.