Toro 30607 Operator's Manual page 30

2. Remove the flange-head bolts and nuts from each skid
(Figure 27).
3. Move each skid to the desired position and secure them
with the flange-head bolts and nuts.
Note: Only use the top or center sets of holes to
adjust the skids. The bottom holes are used when
switching sides at which time they become the top
holes on the other side of the mower.
4. Torque the screw at the front of each skid to 9 to 11
N⋅m (80 to 100 in-lbs).
Adjusting the Cutting Unit Rollers
The cutting unit rollers should be mounted in the lower
position when operating in height of cuts greater than 64 mm
(2-1/2 inches) and in the higher position when operating in
height of cuts lower than 64 mm (2-1/2 inches).
1. Remove the bolt and nut securing the gage wheel to
the cutting unit brackets (Figure 28).
1. Gage wheel
2. Align the roller and spacer with the top holes in the
brackets and secure them with the bolt and nut.
Correcting Mismatch Between Cutting
Units
Due to differences in grass conditions and the counterbalance
setting of the traction unit, it is advised that a sample area
of grass be cut and the appearance checked before formal
cutting is started.
1. Set all cutting units to the desired height of cut; refer to
Adjusting the Height of Cut.
2. Check and adjust front and rear tractor tire pressure to
172-207 kPa (25-30 psi).
3. Check and adjust all castor tire pressures to 345 kPa
(50 psi).
4. Check charge and counterbalance pressures with
engine at high idle using test ports defined in Hydraulic
Figure 28
Systems Test Ports. Adjust counterbalance to 2241 kPa
(325 psi).
5. Check for bent blades; refer to Checking for a Bent
Blade.
6. Cut grass in a test area to determine if all cutting units
are cutting at the same height.
7. If cutting unit adjustments are still needed, find a flat
surface using a 2 m (6 foot) or longer straight edge.
8. To ease measuring blade plane, raise the height of cut
to 7.6 to 10.1 cm (3 to 4 inches); refer to Adjusting the
Height of Cut.
9. Lower cutting units onto the flat surface. Remove the
covers from the top of the cutting units.
10. Loosen the flange nut, securing the idler pulley, to
release the belt tension on each cutting unit.
Front Cutting Unit Setup
Rotate blade on each spindle until the ends face forward and
backward. Measure from the floor to the front tip of the
cutting edge. Adjust 3 mm (1/8 inch) shims on front castor
fork(s) to match height of cut to decal (Figure 29); refer to
Adjusting the Cutting Unit Pitch.
1. Tensioning cap
2. Spacers
3. Shims
Side Cutting Unit Setup
Rotate blade of each spindle until the ends face forward and
backward. Measure from the floor to the front tip of the
cutting edge. Adjust 3 mm (1/8 inch) shims on front castor
arm(s) to match height of cut to decal (Figure 30). For the
outside blade spindle only, refer to Adjusting the Cutting Unit
Pitch.
30
Figure 29
4. Top axle mounting hole
5. Castor wheel