Table of Contents
Advertisement
•
Study all battery pack manufacturer's specific precautions for
charging and take the steps needed to comply with them.
•
This battery pack charger is for use only on nominal 120 and
240 VAC circuits, and is equipped with a grounding plug for
120 VAC operation. For use with 240 volt circuits, contact
your Authorized Parts Dealer for the correct power cord.
CAUTION
Risk of fire or electric shock. Connect the battery
pack charger directly to a grounding receptacle
(three-prong). Do not use this charger on an
ungrounded outlet, even with an adaptor.
Operation
•
General Precautions
–
Never charge a frozen battery.
–
Do not abuse the cord—Never carry the charger by its
cord or yank on the power supply cord to disconnect the
charger from the receptacle. Keep the cord from heat,
oil, and sharp edges.
–
Keep the case intact.
–
When carrying the charger, always be sure of your
footing, and keep a firm hold on the handle. Walk; never
run. Exercise caution to avoid slipping or falling.
•
Personal Precautions
DANGER
Never alter the provided power cord or plug. If it
will not fit the outlet, wait for a qualified electrician
to install a proper outlet. An improper connection
can cause an electric shock.
–
Wear complete eye protection and clothing protection.
–
Immediately wash any skin or clothing that battery
pack electrolyte contacts with soap and water. Should
electrolyte get in your eye, immediately flood the eye
with cold running water for at least 10 minutes and
immediately call for emergency medical service.
–
Do not ever smoke or permit a spark or flame near a
battery.
–
Take extra precautions to avoid dropping a metal tool near
or onto a battery. It might cause a spark or short-circuit
an electrical part that could lead to an explosion.
–
Remove metal items such as rings, bracelets, necklaces,
and watches from your person when working with a
lithium ion battery. A lithium ion battery pack can produce
enough current to cause a severe burn.
–
Use this charger only for charging Toro lithium ion
batteries for the eFLEX Walking Greensmower, as
specified in the equipment's Operator's Manual. Do
not use it for any other purpose.
•
Location
–
Never operate the charger without good visibility or light.
–
Operate the charger in an open area with good ventilation.
•
Output Connection Precautions
–
The charger must always be off prior to connecting or
disconnecting the battery pack to the charger, Never
allow a metal object to touch the recessed pins in the
end of the connector.
–
Comply with the instructions in this manual when you
connect and disconnect the charger and the battery.
•
Power Connection Precautions
–
Grounding—The charger should be grounded to reduce
the risk of electric shock. The electric cord included with
this charger will supply a ground when plugged into a
properly wired grounding outlet installed in accordance
with all local codes and ordinances.
CAUTION
Risk of fire or electric shock. Connect the
battery pack charger directly to a grounding
receptacle (three-prong). Do not use this
charger on an ungrounded outlet, even with an
adaptor.
–
Do not use an extension cord unless absolutely
necessary. Use of an improper extension cord could
increase the risk of fire and electric shock. If you must
use an extension cord, make sure of the following:
◊
The pins on the plug of the extension cord match the
number, size, and shape of those on the plug that
came with the charger.
◊
The extension cord is properly wired and insulated
and is in safe electrical condition.
◊
The wire size large enough for the AC ampere rating
of the charger as specified in the table below.
AC Input Rating
Min
Max
7.6 m
(25 ft)
4 A
5 A
–
Ensure that the charger is turned off prior to plugging the
power supply cord into an electrical outlet.
–
If the power supply cord is damaged in any manner
while it is plugged in, disconnect the cord from the wall
receptacle and contact an Authorized Service Dealer for
a replacement.
–
Disconnect the charger—Unplug the charger from the
electrical outlet when not in use, before moving it to
another location, or prior to servicing it.
–
Always pull the plug rather than the cord when
disconnecting the power supply cord to avoid damage to
the electric plug and cord.
Maintenance and Storage
CAUTION
Risk of electrical shock. Do not attempt to service this
charger unless you are authorized and qualified to do
so.
Store an idle charger indoors. When the charger is not in use, it
should be stored indoors in a dry, secured place out of the reach
of unauthorized users.
Maintain the charger with care.
Replacement parts—When servicing the charger, use only
identical replacement parts.
•
Take the charger to an Authorized Toro Distributor when
service or repair is required.
•
Do not disassemble the charger; incorrect reassembly may
result in a risk of electric shock or fire.
2
Cord Size—Minimum Wire Gauge
(A.W.G.)
Cord Length
15.2 m
30.5 m
(50 ft)
(100 ft)
18
18
14
45.6 m
(150 ft)
12
Advertisement
Table of Contents
