Table of Contents
Advertisement
Disconnecting the Charger
1. Note the percent SOC (state of charge) on the charger LCD
status display.
2. Turn off the charger.
3. Disconnect the charger T-handle connector from the main
battery power supply connector affixed to the battery tray.
Important: Do not pull on the cables
4. Place the charger T-handle and cord in a storage position
that will avoid damage.
5. Ensure the eFlex T-handle and battery pack connectors are
clean.
6. Connect the eFlex T-handle to the battery pack connector
(Figure 14)
G017237
1. T-handle connector
7. Turn on eFlex machine power (See the Operator's Manual)
and verify battery charge displayed on the InfoCenter
matches that as stated on the charger LCD display prior to
powering the charger down.
Note: If the power of the charger is not cycled off prior
to attempting to charge the battery, it will not recognize
that a battery has been re-connected and charging will not
commence.
Maintenance
Important: All electrical repairs should be performed by an
Authorized Service Distributor only.
The operator can perform very little maintenance other than
protecting the charger from damage and weather.
Maintaining the Cords
•
Clean the cords with a slightly damp cloth after each use.
2
1
Figure 14
2. Main power supply
connector on the battery
platform
•
Coil the cords when not in use.
•
Periodically examine the cords for damage, and replace them
when necessary with Toro-approved parts.
Replacing the Fuse
If the charger stops working, check the fuse located under the
cord receptacle (Figure 1). If the fuse is blown, replace it with the
same rated fuse that you removed. Ensure that you insert the fuse
in the orientation appropriate for your voltage.
Cleaning the Case
Clean the case with a slightly damp cloth after each use.
Service
This charger is a solid state device and should not require service
under normal operating conditions and use according to these
instructions. Should it need service, bring the charger to an
Authorized Toro Service Distributor. Repair by service centers not
operated by Toro may result in damage to connected equipment
and is not covered under the warranty.
Storage
1. Complete the procedure for Disconnecting the Charger
(page 7).
2. Disconnect the power supply cord from the charger and coil
it securely.
3. Examine the power supply cord thoroughly for signs of wear
or damage. Replace it if it is worn or damaged.
4. Examine the charger thoroughly for worn, loose, or damaged
parts. To repair or replace parts, contact an Authorized Parts
Dealer for assistance.
5. Store the charger with the power supply cord in a clean,
dry place where it will not be bumped or damaged and not
exposed to caustic fumes.
7
Advertisement
Table of Contents
