Adjusting The Lift And Mow Pedal Height; Leveling The Lift And Mow Pedals - Toro 04356 Operator's Manual

Adjusting the Lift and Mow
Pedal Height
To gain proper spool travel in the valve bank, adjust the lift
and mow pedals to equal heights as follows:
1. Place 1, 2 and 3 spools in neutral (center of travel) and
remove the transfer rod guard from the foot panel
(Fig. 48).
1
Figure 48
1. Transfer rod guard
2. Loosen the jam nut securing the yoke on the front of the
long control rod. Remove the cotter pin and clevis pin.
3. Move the adjustment lever by hand to level the mow
and lift pedals and adjust the yoke on the control rod
until the hole in the yoke lines up with the adjustment
lever hole (Fig. 49).
4
2
Figure 49
1. Jam nut
2. Yoke
1
3
m–5101
3. Control rod
4. Adjustment lever
34
4. Install the clevis pin and cotter pin. Tighten the jam nut
and install the transfer rod guard.
5. Actuate the mow pedal by hand. Be sure the lift pivot
under the pedals clears the stop welded to the frame,
thereby allowing full spool travel.
Leveling the Lift and Mow
Pedals
If the lift and mow pedals are not level when they are in the
neutral position, an adjustment to the lift pivot is required.
1. Loosen the nut on the back side of the lift pivot
(Fig. 50).
2
1
Figure 50
1. Lift pivot
2. Rotate the eccentric screw (Fig. 50) to raise or lower the
lift pivot spring, leveling the lift pivot and pedals.
3. While holding the screw, tighten the nut locking the
adjustment.
2. Eccentric screw