Led Indicators In Surveillance Mode - Motorola APX 3000 User Manual

Transmit/Receive LED
Solid green
–
–
–
–
–
–
–
Note: No LED indication occurs when your radio receives a clear (non-secured) transmission in trunking Mode.

LED Indicators in Surveillance
For covert operation, the LED can be preprogrammed to be
turned off at specific zone or channel. During operation in these
zone or channel the LED blinking is not seen, instead Voice
Announcement can be used to hear and confirm the operation
status.
24
English
Bluetooth LED
Short blinking blue
Radio is reading or upgrading by CPS.
with long interval
Blinking blue three
Bluetooth is powering on or off.
times
Slow Blinking blue Radio is waiting to be paired when no device is connected with radio in Bluetooth.
Blinking blue at
Radio is connected with at least a device in Bluetooth link.
heartbeat pace
Bluetooth device is connected.
Solid blue for two
seconds
Bluetooth device is disconnected.
Blinking blue Radio is clearing Bluetooth pairing information.
Rapid blinking blue
Radio fails to connect or disconnect from a device.
for two seconds
Solid blue Radio is powering up with Option Board error.
Mode†
Status
Hence, It is recommended to duplicate the channel
programming into a separate zone and have the associated
Voice Announcement tied to zone to help indicate the LED on/
off state, for example "Light Off" "Zone 1". Using zone control in
this case eases going into and out of the zone or channel
preprogrammed with the LED on/off setting.