Depths And Nozzle Configurations - Toro 09802 Operator's Manual

Depths and Nozzle Configurations

All nozzles are identified with numbers indicating the drill size of the orifice. The standard configuration is 11
nozzles producing depths of 4 to 6 inches depending on turf conditions. Blocked nozzle locations are obtained by
reversing the nozzle check valve ball and spring. See nozzle size chart and illustrations below:
Important: Use only nozzle configurations shown or damage to the machine may occur.
Part No. Drill Size
86-8130 #56
86-8131 #53
86-8133 #46
Important: Aluminum Washer, Toro Part no. 80-6680, is required with any nozzle change.
Part No. Drill Size
86-8130 #56
86-8133 #46
Important: Aluminum Washer, Toro Part no. 80-6680, is required with any nozzle change.
Open Nozzle
1. Check valve ball
Nozzle Size and Approximate Depth Chart
Decimal Size
(inch)
0.0465
0.0595
0.081
* Use only with varied size configurations
Optional Staggered Size Nozzle Configuration
Decimal Size
(inch)
0.0465
0.081
** Additional nozzles may be blocked to compensate for pump wear.
Figure 6
2. Spring
Quantity of Nozzles
Metric Size
(mm)
Open
1.181 *
1.511 11
2.057 6
Quantity of Nozzles
Metric Size
(mm)
Open
1.181 6 and
2.057 5
1. Spring
14
Blocked
*
0
5
Blocked**
0**
0**
Figure 7
Closed (Blocked) Nozzle
2. Check valve ball
Approximate.
Depth
*
4-6 inches
6-8 inches
Approximate.
Depth
3-4 inches
6-8 inches