Sanyo PLC-WXU30 Owner's Manual page 109

4. Press SELECT button.
LAN setting screen will appear and selected LAN settings will be displayed. Adjust each item to the
setting environment. Consult your system administrator about the detailed settings.
Adjust the figures with the Point
buttons.
5. After completing all the settings, select "Set" and press SELECT button. Now, all procedures have been
done. To cancel the adjusted settings, select "Cancel" and press SELECT button.
To confirm whether the settings are correct, follow the procedures described from the next page.
You can confirm the LAN settings you have made from "Network Information" (p.30). In such cases
that the LAN cannot be connected, see this screen.
Wired setting
Network PIN code
Item Description
DHCP..........................Sets DHCP function On or Off. When you setup the network setting manually, select "Off". When
it set On, IP address, Subnet, Gateway and DNS are automatically set according to your network
environment *
IP address .................Sets IP address of the projector
Subnet .......................Sets Subnet mask. Normally sets 255.255.255.0
Gateway* .................Sets IP address of the default gateway (Router)
2
DNS* ..........................Sets IP address of the DNS server.
2
*1 Set "On" only when the DHCP server is available on your network environment.
*2 Set [255.255.255.255] if the network does not provide the gateway (router).
*3 Set [255.255.255.255] if you do not use the function E-Mail alert.
* While the network communication finction (p.85) or moderator function (p.103) is to be executing, the menus
"Network capture", "Network viewer" and "Memory viewer" are displayed in gray.
buttons and move among the items with the Point
Wired LAN setting screen (Example)
1 .
Network environment setting
27