Sanyo PLC-WXU30 Owner's Manual page 69

The image is distorted or runs off.
PIN code dialog box appears
at start-up.
Page Up/Down function does
not work.
The Remote Control does
not work.
Alarm does not stop ringing.
Indicator blinks or lights.
Wireless Mouse function does
not work.
The exclamation mark appears
on the screen.
Top control does not work.
Uable to unlock the Logo PIN
code lock, Security key lock
or Security PIN code lock.
– Check "PC adjustment" menu or "Screen" menu and adjust them.
(page 33-34, 38-39)
– PIN code lock is being set. Enter a PIN code (the "1234" or numbers
you have set). See pages 22, 54–55.
– Make sure your computer is connected to the projector with USB
cable.(see page 19)
– Check cable connection between the projector and your computer.
(see page 19)
– Check the batteries.
– Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Wireless reomete control does not work when the remote control
cable is connected to the projector.(see page 13)
– Make sure the code of the remote control is conformed to the
projector's code. See page 53.
– Unlock the Key lock function for the remote control function. See
page 54.
– Check RESET/ON/ALL-OFF switch on the remote control is set to
"ON". See page 15.
– Connect the AC power cord to the AC outlet. (Alarm will not
stop ringing when the alarm goes off while trying to remove the
rechargeable battery cover.)
– Chek the status of the projector with referring to "Indicators and
projector Condition".(see page 73 )
– In the case of the ALARM indicator blinks, check the setting.(see
page 58)
– Check the connection between a projector and your computer.
– Check the mouse setting on you computer.
– Make sure the mouse driver is installed on your computer,
otherwise, the remote control can not be used as a wireless mouse.
– Make sure the signal is from the computer, otherwise, the remote
control can not be used as a wireless mouse.
– Turn on the projector before turning on the computer.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top cotrol is locked at "Key lock"
under "Security" of SETTING section. Please check "SETTING"
section on page 54.
– Contact the dealer where you purchased the projector or the service
center.
Appendix
69