Basic Parameters; Setting The Chamber Temperature, Co; Density - Sanyo MCO-19M Service Manual

BASIC PARAMETERS

Setting the chamber temperature, CO

The setting procedure for the chamber temperature, CO
settings: Chamber temperature: 37
The Incubator automatically starts operation using these settings after the power is turned ON.
1. From the Top Display, press the MENU Key to access the menu. Select Set and press the ENTER
Key.
T e m p 3 7 . 0
1
2
３７.０
3
4
S t a t u s
5
O K
6
7
2. The Stand-By Setting Display will be displayed. Set the parameters.
S t a n d - b y
1
T e m p e r a t u r e
2
C O 2
3
O 2
4
5
K e y
H i g h
6
The setting ranges of the parameters are as follows:
Temperature: 0 to 50
CO density: 0 to 20%. To set 5.0%, enter 050.
2
O density: 1 to 18 and 22 to 80%. To set 5.0%, enter 050.
2
3. Press the MENU Key to display the menu after setting the parameters. Select OK and press the
ENTER Key. The settings will be saved.
Note:
When starting the Incubator for the first time or after not using it for an extended period of time, allow at
least 4 hours for the chamber temperature, humidity, CO
setting the desired chamber temperature at a 0% CO
setting to the desired CO
25
o
C, CO density: 0%, O
2
o
C C O 2
S e t t i n g
3 7 . 0
D e n s i t y 0 . 0 %
D e n s i t y 2 0 . 0 %
L o c k
L i m i t 5 2 . 0
o o
C. To 37.0 C, enter 370.
and O

density.

2 2
2
and O density are given below. (Default
2 2
density: 20%)
2
5 . 0 % O 2
５.０
o o
C ( 0 . 0
( 0 . 0 %
( 1 . 0 %
( 2 2 . 0 %
0 ( 0 . U n l o c k
o
C
sensor and O
2
density and a 20% O
2
- 132 -
and O density
2
5 . 0 %
M E N U
５ .
５.０
S e t
L o g
T o o l s
M E N U
o
C - 5 0 . 0 C )
O K
- 2 0 . 0 % )
C a n c e l
- 1 8 . 0 % )
- 8 0 . 0 % )
1 . L o c k )
sensor to become stable after
2
density. Then change the
2