Toro greensmaster 3100 Operator's Manual page 17

the switch and turn it clockwise to the START
position to start the engine. Release the key as soon
as the engine starts. Turn the key counter-clockwise
to OFF to stop the engine
VOLTMETER (Fig. 13)—The ammeter shows the
electrical system voltage.
FUSE (Fig. 13)—The 10-amp fuse is part of the
electrical circuit.
LEAK DETECTOR TEST/LIGHT SWITCH (Fig.
13) From the middle operating position, move the
switch rearward to check the operation of the leak
detector alarm and time delay. Move the switch
forward to operate optional headlights.
HOUR METER (Fig. 13)—Shows the total hours of
machine operation. The hour meter starts whenever
the key switch is turned to ON.
SEAT ADJUSTING HANDLE (Fig. 13)—Located
on the left side of the seat, this lever allows four inch
fore-and-aft adjustment.
MOW LOCKOUT LEVER (Fig. 14)—locks the
mow pedal, preventing accidental starting of the
cutting units. To unlock, pull the mow lockout pin
outward, rotate it clockwise and insert the end into the
rear hole in the bracket.
1. Mow lockout lever pin
SHIFT SELECTOR (Fig. 15)—Provides two
traction selections, plus a NEUTRAL position. It is
permissible to shift from one selection to another
while the machine is in motion. No damage will
result.
Figure 14
1. Neutral—Used for starting the engine.
2. No. 1 Position—Used for greens mowing
operation.
3. No. 2 Position—Used for transport operation.
NOTE: If you operate the machine in reverse with the
cutting units down, they will be pulled off the lift
arms.
STEERING ARM LOCKING LEVER (Fig. 15)—
Rotate the lever rearward to loosen, then raise or
lower the steering arm for comfort. Then rotate the
lever forward to tighten.
To adjust the locking lever:
1. Rotate the lever rearward to loosen adjustment
and move the steering arm to its lowest position.
2. Loosen the lever set screw.
3. Rotate the adjusting bolt (left-hand thread)
counter-clockwise to tighten, or clockwise to
loosen the adjustment.
4. Tighten the set screw to lock the adjustment.
3
1. Shift selector
2. Steering arm locking lever
3. Set screw
4. Adjusting bolt
17
2
4
Figure 15
1