Separating The Cutting Unit From The Traction Unit - Toro 30716 Operator's Manual

Figure 16
Figure 17
Position the machine and cutting unit on a level surface
and lower the cutting unit. Remove the dipstick/fill plug
from the top of the gear box (Figure 18) and make sure
that the lubricant is between the marks on the dipstick.
If the lubricant level is low, add SAE 80-90 wt. gear lube
until the level is between the marks
1. Dipstick/fill plug
Separating the Cutting Unit
from the Traction Unit
1. Position the machine on level surface, lower the cutting
unit to the floor, shut the engine off and engage the
parking brake.
2. Remove the self-tapping screws securing the shield to
the top of the cutting unit and set the shield aside.
3. Drive out the roll pin securing the drive shaft yoke to
the input shaft of the gear box (Figure 19). Loosen the
capscrews and locknuts and slide the yoke off of the
input shaft. If the traction unit will be used without
the cutting unit, drive the roll pin out of the yoke at
traction unit PTO shaft and remove the entire drive
shaft from the traction unit.
1. Drive shaft yokes
2. Yokes in phase
17
Figure 18
Figure 19
3. Roll pin and capscrews