Table of Contents
Advertisement
in the Adjusting the Height of cut section . Slide a
thrust washer onto the spindle. Push the large castor
spindle through the front castor arm and the small
castor spindle through the rear castor arm. Install
another thrust washer and the remaining spacers onto
the spindle and install the tensioning cap to secure the
assembly (Figure 2 & Figure 3).
Important: The thrust washers, not the spacers,
must contact the top and bottom of the castor arm.
1. Tensioning cap
2. Thrust washers
3. Ensure that all four castor wheels are set at the same
height-of-cut; then roll the cutting unit off of the
wooden pallet.
2
Installing the Drive Shaft to the
Traction Unit
Parts needed for this procedure:
1
Drive shaft
Procedure
Slide the smaller yoke end of the drive shaft onto the traction
unit PTO shaft while aligning the mounting holes (Figure
4). Secure them with a roll pin. Do not install the front end
of the drive shaft at this time.
Figure 3
3. Spacers
4. Small (rear) castor spindle
1. Drive shaft
3
Connecting the Right-Hand
Push Arm to the Cutting Unit
No Parts Required
Procedure
WARNING
The right-hand push arm is spring loaded to about
45 kg (100 lb.). Sudden release of the push arm
could cause injury.
Another person is needed to push the arm down
during this procedure.
1. Remove the 2 self-tapping screws securing the PTO
shield to the top of the cutting unit gear box mounting
plate and remove the shield (Figure 5).
1. PTO shield
9
Figure 4
Figure 5
Advertisement
Table of Contents
