Installing The Debris Skirt To The Traction Unit - Toro 02835 Operator's Manual

5

Installing the Debris Skirt to the Traction Unit

Parts needed for this procedure:
1 Flap mount
6 Carriage bolt (M8)
6 Flange nut (M8)
Procedure
Use 6 carriage bolts (M8), 6 flange nuts (M8), and the flap mount to secure the debris skirt to the axle bracket.
Note:
For easier access to this area, you may remove a front wheel or both front wheels. Refer to the Setup
section in the traction unit Operator's Manual for wheel removal and installation instructions.
1. Flange nut (M8)
2. Flap mount
Figure 14
3. Debris skirt
4. Carriage bolt (M8)
12
g383966