Product Overview; Controls - Toro 07050 Operator's Manual

Product Overview

Controls

Flap Lever
Move the flap lever downward to the engaged position
and upward for the disengaged position. Move the lever
to the upward position when transporting the machine.
Reel Lever
Push the reel lever forward to raise the flex tip reel. To
lower the flex reel, push the lever forward until the catch
releases, then push to the rear until the lever hits Stop.
Move the lever to the raised position when the machine
is not in operation, when storing the machine, or when
transporting the machine (Figure 4).
2 1
1. Flap lever
Choke Control
To start a cold engine, close the carburetor choke by
moving the choke control lever to the On position.
After the engine starts, regulate the choke to keep the
engine running smoothly. Open the choke by moving
the lever to the Off position. Starting a warm engine
requires little or no choking (Figure 5).
g015265
Figure 4
2. Reel lever
2
1. Choke control
2. Ignition switch
Ignition Switch
The ignition switch, which is used to start and stop the
engine, has three positions: Off, Run, and Start. Rotate
the key clockwise to the Start position to engage the
starter motor. Release the key when the engine starts.
The key will move automatically to the Run position.
To shut the engine off, rotate the key counterclockwise
to the Off position.
Throttle Control
The throttle is used to operate the engine at various
speeds. Moving the throttle lever to the Fast position
increases the engine speed. To decrease the engine
speed, move the lever to the Slow position.
Tailgate Latch Rope
Pull the tailgate latch rope to unlatch the tailgate when
emptying the hopper (Figure 6).
1. Tailgate latch rope
11
3 1
g015266
Figure 5
3. Throttle control
2 1
g015267
Figure 6
2. Jack handle