Toro 07050 Operator's Manual page 28

H. Stop the engine, allow it to cool and drain the
fuel tank.
I. Restart the engine and run it until it stops.
J. Choke the engine. Start and run the engine until
it will not start.
K. Dispose of the fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned gasoline over 90
days.
8. Remove the spark plugs and check the condition;
refer to Servicing the Spark Plugs (page 19). With
the spark plugs removed from the engine, pour
two tablespoons of engine oil into each spark plug
hole. Now use the starter to crank the engine and
distribute the oil inside the cylinders. Install the spark
plugs. Do not install the wires on the spark plugs.
9. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is damaged or defective.
10. Wash and dry the entire unit. Remove the tines, clean
and oil them. Spray light oil mist on the coring head
bearings (crank & damper links).
Important: You can wash the machine with
mild detergent and water. Do not pressure wash
the machine. Avoid excessive use of water,
especially near the engine.
Note: Run the machine with the engine at high idle
for 2 to 5 minutes after washing.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Distributor.
12. Secure service latch if the aerator is to be stored for
more than a couple days.
13. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it out of reach of children or other unauthorized
users.
14. Cover the machine to protect it and keep it clean.
28