Lubrication; Oil The Sweeper Jack - Toro 07050 Operator's Manual

Lubrication

Lubrication
Service Interval: Every 25 hours
The Rake–O–Vac has grease fittings that must be
lubricated regularly with No. 2 General Purpose Lithium
Base Grease. Lubricate the bearings after every 30
hours of operation or whenever machine is washed
with water. Bearings and bushings must be lubricated
daily when operating conditions are extremely dusty
and dirty. Dusty and dirty operating conditions could
cause dirt to get into the bearings and bushings, resulting
in accelerated wear. The grease fittings that must be
lubricated are: the gauge wheel bearings, the reel shaft
bearings, the impeller shaft bearings, the jackshaft
bearings, and the left and right trailing arms.
1. Wipe the grease fittings clean to ensure that foreign
matter cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing (Figure 14,
Figure 15, and Figure 16).
Figure 14
3. Wipe up any excess grease.

Oil the Sweeper Jack

Service Interval: Every 50 hours—Oil the Sweeper
Oil the Sweeper jack after every 50 hours of operation
(Figure 17).
g015268
17
Figure 15
Figure 16
Jack.
Figure 17
g015269
g015270
g015271