Toro 30506 Operator's Manual page 13

Figure 22
1. 2-1/2 inches
2. Secure the top mounting hole of the front mounting
plate of the bumper to the castor arm bracket with a
bolt (5/16 -18 x 3 inch) and locknut
Figure 23
1. Bumper
3. Using both mounting plates of the bumper as
templates, locate, mark, and drill 3 additional 11/32
inch diameter holes through both walls of the front and
rear castor arm brackets.
2. 3/8 inch
(Figure 23).
11
Installing the New Deck Cover
Parts needed for this procedure:
1 Trim molding
1 Deck cover
Procedure
1. Insert a trim molding onto the right bridge bar, so the
side of the spring bracket is 10 cm (4 inches) to the far
edge of the trim molding
1. Trim molding
2. Cover
2. Hook the rear of the deck cover
rear channel pin while aligning the cover mounting
bolt with the hole in the right castor arm. The cover
is to rest on the trim molding. Adjust the molding as
required.
3. Secure the cover to the right castor arm with the bolt.
12
Installing the New Safety
Guards
Parts needed for this procedure:
1 Belt guard
1 Pulley guard
Procedure
1. Install the belt guard onto the machine
Note: Use existing hardware on the machine by
removing it and using it to install the guard.
13
(Figure 24).
g029097
Figure 24
3. Bolt
(Figure 24) onto the
(Figure 25).