Toro 30506 Operator's Manual page 15

14
Installing the Cutting Unit to
the Traction Unit
No Parts Required
Procedure
1. Engage the parking brake, ensure that the traction pedal
is in neutral and the PTO lever is in the Off position.
Start the engine and raise the lift arms. Stop the engine.
2. Position the cutting unit in front of the traction unit
aligning the gear case input shaft with the PTO shaft
and install the shaft.
3. Carefully lower the lift arms while aligning the lift arm
brackets with the castor arms. Align PTO shaft hole
with gear case input shaft hole and install roll pin.
4. Secure the lift arm brackets and the side of the blower
brace to the castor arms with 4 bolts and nuts.
5. Start the engine and raise the cutting unit. Secure
the counterbalance springs to the cutting unit with
shoulder bolts and locknuts.
15
Installing the New Decal
Parts needed for this procedure:
1 Decal, danger
Procedure
Install the Danger Decal (Part Number 66-1340 or 93-7824
for CE) on the front edge of the deck, inside the right castor
arm.
16
Mounting the Blower Housing
Chute
Parts needed for this procedure:
1 Chute assembly
Procedure
Important: When the chute in the Blower Kit is used
with a 15 cubic foot Hopper Kit, you must cut off a
section of the chute to ensure proper fit between the
blower and the hopper. If used with another kit, proceed
to step 3.
1. Using the dimensions shown in
measure and mark the chute.
Note: For convenience, some chutes may have a light
scribe mark where the chute must be cut off.
1. 61.2 cm (24.12 inches)
2. Draw lines around all sides of the chute and cut off
with a saw.
3. Set the deck to the desired height-of-cut setting.
4. Slide the chute over the blower opening and onto the
mounting studs
15
Figure 28, use a tape
Figure 28
2. 70.5 cm (27.75 inches)
(Figure 29).