Table of Contents
Advertisement
Connection/Installation
Connection (Continued)
If thin cables are used, the resistance of the cables will be
Memo
high and a significant voltage drop will occur when the
camera is at its maximum power consumption. Either use a
thick cable with low resistance or place the power supply
near to the camera and shorten the length of the cable to
restrict the voltage drop at the rated current of camera to
below 10 %. If voltage drop occurs during operation, the
performance will be unstable.
Do not connect an AC 24 V cable to a commercial power
supply. If it is connected by mistake, the internal circuit may
be damaged. Sent the camera to the nearest JVC service
center for inspection as the internal circuit may be damaged.
Do not connect DC 12 V and AC 24 V cables at the same
time.
When using a DC 12 V power supply, ensure that the
polarities of the cable are correct.
Connecting the Monitor
Connect with a 75 K coaxial cable (BNC) such as RG-59 or equivalent.
E-18
Advertisement
Table of Contents
