Correcting Distortion In The Projected Image - Epson EMP-1815 User Manual

Correcting Distortion in the Projected Image

There are four ways to correct distortion in projected images as below.
Automatic correction
• Quick Setup
Press the [Quick Setup] button to fit on the screen at an aspect ratio
of 4:3.
• Auto V-Keystone
Tilt the projector vertically to automatically correct distortion in the
vertical direction.
Manual correction
• Quick Corner
This allows you to manually correct each of the four corners of the
projected image separately.
• H/V-Keystone
This allows you to manually correct distortion in the horizontal and
vertical directions independently.
The "Quick Setup", "Quick Corner", "Auto V-Keystone" and "H/V-
Keystone" functions project a test pattern onto the screen to correct
the projected image, so connection to a computer for preparing the
projector is not required.
Downloaded from ProjectorsManual.com Manuals
• The default setting in the configuration menu is H/V-
q
Keystone.
• Select "Settings" - "Keystone" - "Quick Corner" to use
Quick Corner for correction.
• To change the setting from Quick Corner to H/V-Keystone,
press and hold the [Esc] button on the projector or the
remote control for about two seconds and display the
following screen where you can make the change.
Reset Quick Corner: Resets the Quick Corner settings.
Switch to H/V-Keystone: Switches the keystone correction method to
H/V-Keystone. s p.43
16