HP 240 Maintenance And Service Manual page 85

Remove the keyboard:
1.
Remove the Phillips PM2.5×4.0 screw that secures the keyboard to the computer just below the
WLAN module slot.
2. Rest and secure the computer on its left side with the bottom toward you, and then partially open
the computer.
3. Using a flat-bladed screwdriver or similar tool, push the tabs of the 4 keyboard clips (1) that are
visible inside the battery bay towards the rear of the computer to loosen the keyboard.
4. Insert a screwdriver or similar small tool into the keyboard release hole (2), and then press on the
back of the keyboard until the keyboard disengages from the computer.
5. Turn the computer right-side up with the front toward you.
Component replacement procedures
77