Table of Contents
Advertisement
4.2
Firmware development
For the two modes of operation, independent and Arduino mode, we will explain separately
the development process. We will also give a brief introduction in this section on the
programming of the Bluetooth module built on the evaluation kit.
4.2.1 Development Tools
The following tools are needed when developing application for Grid-EYE Sensor board.
Hardware
1. PC with at least 2 USB interface
2. Micro-USB cables
3. TTL Serial to USB module (only to program Bluetooth module PAN 1740)
4. J-Link
Software
Users need to install the following software according to the target they develop:
Software
Description
Develop the code for
Atmel Studio
ATSAMD21
Program ATSAMD21, if JTAG
SAM-BA
is not available
Develop the code for Arduino
Arduino IDE
mother board
Develop the code for
Keil MDK
Bluetooth module
Smart Snippet
Program Bluetooth module
User Manual
Download link
http://www.atmel.com/tools/ATMELSTUDIO.aspx
http://www.atmel.com/tools/ATMELSAM-BAIN-
SYSTEMPROGRAMMER.aspx
https://www.arduino.cc/en/Main/Software
http://www.keil.com/arm/mdk.asp
http://support.dialog-
semiconductor.com/product/da14580
Grid-EYE Evaluation Kit
19
Advertisement
Table of Contents
