Replacing the display cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1
Adhere the tape that secures the display cable to the display-panel
assembly.
2
Route the display cable through the routing guides on the display-panel
assembly.
3
Slide the display cable into the connector on the display panel and close
the latch to secure the cable.
4
Adhere the tape on the display-cable connector.
5
Slide the sensor-board cable into the connector on the sensor board and
close the latch to secure the cable.
6
Adhere the tape on the sensor-board connector.
Post-requisites
1
Replace the camera.
2
Follow the procedure from step 5 to step 6 in
panel".
3
Replace the
display
4
Replace the battery.
5
Replace the
base
computer. After working inside your
assembly.
cover.
After working inside your
"Replacing the display
93