Removing the sensor board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Prerequisites
1
Remove the
2
Remove the battery.
3
Remove the
4
Follow the procedure from step 1 to step 2 in
panel".
Procedure
CAUTION: Place the display-panel assembly on a soft and clean
surface to avoid scratching the display.
1
Place the display-panel assembly face down on a flat surface.
2
Remove the screw that secures the sensor board to the display panel.
3
Peel off the tape that secures the sensor-board cable to the sensor
board.
4
Open the latch to disconnect the sensor-board cable from the sensor
board.
100
computer. After working inside your
base
cover.
display
assembly.
After working inside your
"Removing the display