Recording Setup Screen; Tc/Ub Setup Screen - Panasonic AG-3DA1E Operating Instructions Manual

Setup menu list (continued)

RECORDING SETUP screen

Item
REC FORMAT
MIC ALC
MIC GAIN1
MIC GAIN2

TC/UB SETUP screen

Item
TC MODE
TCG
TC PRESET
UB PRESET
80
Display
mode
(Camera) Selects the recording format.
When SYSTEM FREQ is set to 59.9 Hz
PH 1080/60i
PH 1080/30P
PH 1080/24P
PH 720/60P
• PH 1080/4P represents native recording.
When SYSTEM FREQ is set to 50 Hz
PH 1080/50i
PH 1080/25P
PH 720/50P
(Camera) Sets mic level auto control to ON or OFF.
ON OFF
Set to ON to reduce distortion at high input levels.
To adjust the recording level of audio signals (not related to this setting), use
the AUDIO LEVEL knobs.
(Camera)
Sets the input level of the external microphone connected to the INPUT 1
terminal. (Page 48)
-50dB -60dB
(Camera) Sets the input level of the external microphone connected to the INPUT 
terminal. (Page 48)
-50dB -60dB
Display
mode
(Camera) Selects the correction mode of the internal time code generator when the time
code of the internal time code generator is recorded.
DF: Uses the drop frame mode.
NDF: Uses the non-drop frame mode.
• TC MODE is automatically set to NDF when you set recording frame rate of
recording format to 4P. (Only when SYSTEM FREQ is set to 59.9 Hz)
(Camera) Sets the mode in which you advance the internal time code generator.
FREE RUN: The time code is advanced regardless of the operation mode.
• A slight time error may occur when switching to PB mode if the frame rate is
set to 4P. (Only when SYSTEM FREQ is set to 59.9 Hz)
REC RUN:
(Camera) Sets the initial time code.
YES NO
• Set the frame value to 0 or a multiple of 4 when you set recording frame
rate of recording format to 4P. If any other value is set, the recorded time
code will mis-match. (Only when SYSTEM FREQ is set to 59.9 Hz)
(Camera) Sets the user information.
YES NO
Description of settings
Description of settings
The time code is advanced only when recording.
indicates the factory setting.