Philips 200P7ES/00 Service Manual page 76

200P7 LCD
76
Go to cover page
4.1 Test conditions
4.2
Item H.Freq.
(KHz)
1 31.469
2 31.469
3 31.469
4 37.500
5 35.156
6 37.879
7 46.875
8 48.363
Remark : Mode 14:/ 15 1600 * 1200 70 Hz and 75Hz only supported by analog signal , DVI can t support these mode.
4.3 Brightness : >=200 nits (at panel color temperature, at center of the screen, set contrast
2005-12-02
Jerry Chen
GENERAL PRODUCT SPECIFICATION
Unless otherwise specified, this specification is defined
under the following conditions.
(1) Input signal : As defined in 3.3, 1600x 1200
non-interlaced mode (75K/60Hz), signal
sources must have 75 ohm output impedance.
(2) Luminance setting
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 +/- 5 °C
Resolution
Factory preset modes ( 15 modes )
Mode Resolution
IBM VGA 10H 640x350
IBM VGA 3H 720x400
IBM VGA 12H 640x480
VESA 640x480
VESA 800x600
VESA 800x600
VESA 800x600
VESA 1024x768
Note : 1. Screen displays at 36 preset modes
2. Screen displays perfect picture at 15 factory preset modes
3. Screen displays visible picture with OSD warning when input modes
are other then 22 preset modes
and brightness at maximum. )
20.1" TFT UXGA LCD MONITOR
(HUDSON 7-200P)
TYPE :200P7ES/00
BRAND : PHILIPS
2005-12-02
: controls to be set to 200 nits with
full screen 70 % duty cycle white signal
V.Freq. Item H.Freq.
(Hz) (KHz)
70.086 9 60.023
70.087 10 68.700
59.940 11 63.981
75.000 12 79.976
56.250 13 75.0
60.317 14 87.5
75.000 15 93.75
60.004
8639 000 16916
27
590
Mode Resolution
VESA 1024x768
MACINTOS 1152x870
H
VESA 1280x102
4
VESA 1280x102
4
VESA 1600x120
0
VESA 1600x120
0
VESA 1600x120
0
18
V.Freq.
(Hz)
75.029
75.000
60.020
75.025
60
70
75