Sony SRS-X11 Help Manual page 55

3. Perform the pairing procedure on the BLUETOOTH device to detect the speaker.
When a list of detected devices appears on the display of the BLUETOOTH device, select "SRS-X11."
If a passkey* is required on the display of the BLUETOOTH device, enter "0000."
*
A passkey may be called "Passcode", "PIN code", "PIN number" or "Password."
4. Make the BLUETOOTH connection from the BLUETOOTH device.
When the BLUETOOTH connection is established, the
If the BLUETOOTH connection is not established, repeat from step 2.
Hint
For details on operating a BLUETOOTH device, refer to the operating instructions supplied with the BLUETOOTH
device.
Note
The pairing mode of the speaker is released after about 5 minutes and the
slowly. However, when pairing information is not stored in the speaker, such as at the factory settings, the pairing
mode is not released. If the pairing mode is released before finishing the process, repeat from step 2.
When pairing with a BLUETOOTH device that cannot display a list of detected devices or that has no display, you
may be able to pair the device by setting both the speaker and the BLUETOOTH device to pairing mode. At this time,
if a passkey is set besides "0000" on the BLUETOOTH device, pairing cannot be done with the speaker.
Once the BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
The speaker is already paired with eight devices and another device is to be paired.
The speaker can be paired with up to eight devices. If a new device is paired after eight devices have already been paired,
the paired device with the oldest connection time is replaced by the new one.
When the pairing information of the speaker has been deleted from the BLUETOOTH device.
When the speaker is initialized, all the pairing information is deleted.
(BLUETOOTH) indicator stays lit.
(BLUETOOTH) indicator flashes
51