Sony SRS-X11 Help Manual page 78

Hide thumbs Also See for SRS-X11:

Table of Contents

The speaker may not be connected with a BLUETOOTH mobile phone with HFP or HSP. Check the connection

status on the BLUETOOTH mobile phone.

Switch the call device to the speaker by pressing and holding the

3. Adjust the volume by pressing the VOL (volume) –/+ buttons on the speaker or operating the BLUETOOTH mobile

phone.

4. To end a call, press the

If you were listening to music before the call, playback will resume when the call ends.

If you end a call by operating the BLUETOOTH mobile phone, playback will also resume when the call ends if you

were listening to music before the call.

Hint

The volume of music playback and calling is set independently in the speaker.

If the caller cannot hear or can barely hear your voice, talk more directly into the microphone of the speaker.

Note

When using the speaker add function, sound of the phone call is output from only the speaker where the

(BLUETOOTH) indicator is lit.

Depending on the BLUETOOTH mobile phone, playback may not pause when making a call.

Use a BLUETOOTH mobile phone at least 50 cm away from the speaker. Noise may result if the speaker and the

BLUETOOTH mobile phone are too close.

When an audio cable is connected to the AUDIO IN jack of the speaker, you cannot listen to music of the

BLUETOOTH device. However, when the BLUETOOTH connection is active, the hands-free function is available.

Table of Contents

Troubleshooting