Problems With Application Programs - Siemens M105 Operating Instructions Manual


Configuration management
Fault
Message from configura-
tion program: "Data adapt-
er not found..."
Message from configura-
tion program: Registration
not possible.
PIN entered is rejected

Problems with application programs

Fault
PC-PC direct cable con-
nection under WIN98 can-
not be configured or is not
working.
Fax function is not working. SW and modem simulate a
Programs that use DCD
(Data Carrierer Detect) are
not working properly.
Cause
The COM port used is being
used by another program.
The base station may not have
been ready for registration or
the radio connection was tem-
porarily affected by "external
influences".
The PIN entered does not
match the valid PIN.
Cause
Baud rate not correctly set.
Class1 fax.
Find out about additional settings in the modem manual or descrip-
tion of your fax software. (The AT command AT+FCLASS=? is use-
ful, provided this is supported by the modem. If the modem's answer
string contains a 2, then your modem supports Class 2 fax mode).
The DCD output at the local
adapter is controlled by the
DCD input at the remote adapt-
er.
A
Close the application that is using
the COM port.
Repeat registration with a base that
is ready. The PIN must be entered
for this (factory setting: "0000").
See "Registering a portable part"
on page 16
If you forgot the current PIN, reset
the Gigaset M105 Data unit to the
factory defaults. The preset PIN is
"0000".
See "PC-PC direct cable connec-
tion: via RS232/V.24 interface"
on page 26
Class 1 fax mode is not supported
by Gigaset M105 Data for technical
reasons. Gigaset M105 Data sup-
ports Class 2 fax mode.
Use a null-modem cable at the re-
mote adapter.
Back
What happens if...
Solution
.
Solution
.
37