D-Link DIR-879 User Manual page 81

Section 4 - Configuration - Router Mode
Advanced Settings - DHCP Server
Status: Enable or disable the DHCP server.
DHCP IP Address Enter the starting and ending IP addresses for the DHCP server's IP
Range: assignment.
Note: If you statically (manually) assign IP addresses to your computers
or devices, make sure the IP addresses are outside of this range or you
may have an IP conflict.
DHCP Lease Time: Enter the length of time for the IP address lease in minutes.
Always Broadcast: Enable this feature to broadcast your networks DHCP server to LAN/
WLAN clients.
Advanced Settings
WAN Port Speed: You may set the port speed of the Internet port to 10 Mbps, 100 Mbps,
1000 Mbps, or Auto (recommended).
UPnP:
Enable or disable Universal Plug and Play (UPnP). UPnP provides
compatibility with networking equipment, software and peripherals.
IPv4 Multicast Enable to allow IPv4 multicast traffic to pass through the router from
Stream: the Internet.
IPv6 Multicast Enable to allow IPv6 multicast traffic to pass through the router from
Stream: the Internet.
Click Save when you are done.
D-Link DIR-879 User Manual
Network (continued)
77