Installing Thin Client Options; Removing And Replacing The Battery - HP t505 Hardware Reference Manual

Installing Thin Client Options

Various options can be installed on the thin client:
Removing and Replacing the Battery on page 12
●
External Drives on page 13
●

Removing and Replacing the Battery

Before beginning the replacement process, review
for procedures you should follow before and after installing or replacing hardware.
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1. Locate the battery on the system board.
2.
To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
Figure 2-2
3. To insert the new battery, slide one edge of the replacement battery under the holder's lip with the
positive side up (2). Push the other edge down until the clamp snaps over the other edge of the
battery.
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and
rechargeable batteries. For more information about recycling programs, go to
go/recycle.
12 Chapter 2 Hardware Changes
Before removing the side access panel, ensure that the thin client is turned off and the
Removing and replacing the internal battery
Batteries, battery packs, and accumulators should not be disposed of together with the general household
waste. In order to forward them to recycling or proper disposal, please use the public collection system or
return them to HP, an authorized HP partner, or their agents.
General Hardware Installation Sequence on page 9
http://www.hp.com/