Basic Hardware And Configuration (Level 3); Hardware Assignment And Input Type - ABB COMMANDER 150 User Manual

...4 CONFIGURATION MODE
4.3 Basic Hardware and Configuration (Level 3) – Fig. 4.3

4.3.1 Hardware Assignment and Input Type

LEVEL3
A 1KC0
b 1KC0
C 1KC0
d 1KC0
E 1203
Information.
Count High Calculation
Convert flow rate into units/sec =
Count High =
counter factor
Counter factor is the engineering value of the least significant digit shown on the
totalizer display – see Section 4.3.3.
Totalizer Count Pulse
The totalizer count pulse is on for a preset time of 250ms and off for a minimum of
250ms.
20
Level 3
Note. To select to this frame from anywhere in
this level, press the
'ABCD' Settings
The first character (
to be changed. The current setting is indicated by a
flashing letter. Parameter options are shown in Fig. 4.3.
= Hardware configuration
A
= Input type and range
b
= Temperature units
C
= No. of decimal points
d
Note 1. The temperature ranges default to their
maximum values when the input type is changed.
Note 2. For custom settings contact the local
distributor.
Continued on page 22.
flow range time units (in seconds)
units/sec
resultant must be >0.001 and <99.999pps.
key for a few seconds.
, , or
A b C d
actual engineering flow rate
) identifies the parameter