Installation Surface; Built Under Or Built In Appliance Installation - Bosch WFO2466GB Instruction Manual

Installation surface

Built under or
built in appliance
installation
46
Appliance stability is important so that the washing
machine does not "wander" during the spin cycles.
The installation surface must be solid and level. Soft
floor coverings, e.g. carpets or floor coverings with
a foam backing are not suitable.
If the washing machine is to be installed on a wooden
floor:
q If possible, install the washing machine in a corner.
q Screw a water resistant wooden board (at least
30 mm thick) to the floor.
q Secure the washing machine feet with fixing
brackets*.
If the washing machine is to be installed on a base:
q Secure the washing machine feet with fixing
brackets*.
* Holding brackets (set) can be obtained from
a specialist store or the Customer Service,
order no. WMZ2200.
The appliance must be built under or built in prior to
connecting the power supply.
The appliance can be built into or under a kitchen
work surface. For this purpose, a recess width of
60 cm is required.
q The washing machine must only be installed under
a one piece worktop that is permanently attached
to the surrounding cabinets.
Attention
For safety reasons in built under installation, a metal
cover* must be assembled by a specialist in place of
the appliance cover plate.
* Holding brackets ( (set) can be obtained from a
specialist store or the Customer Service, order no.
WMZ 2390.