Installation - Panasonic CQ-DVR909U Operating Instructions Manual

Installation

Installation
E
N
G
L
I
The installation information is designed for experienced installers and is not intended for
S
H
non-technical individuals. It does not contain warnings or cautions of the potential
dangers involved in attempting to install this product.
35
Any attempt to install this product in a motor car by anyone other than a qualified
installer could cause damage to the electrical system and could result in serious personal
injury or death.
Overview
This product should be installed by a
professional. However, if you plan to install this
unit yourself, your first step is to decide where
to install it. The instructions in these pages will
guide you through the remaining steps:
(Please refer to the "WARNING" statement
above.)
≥ Identify and label the car wires.
≥ Connect the car wires to the wires of the
power connector.
≥ Install the unit in the dash.
≥ Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Installation Hardware
No.
1
Shipping Bracket
(For installing the Power Amplifier Unit)
2
Power Amplifier Unit
3
Velcro Tape
4
Binding Screw
(5 mm·k12 mm)
5
Mounting Collar
6
Hex. Nut (5 mm·)
54
CQ-DVR909U
Item Diagram
WARNING
Caution: This unit operates with a 12 volt DC
negative ground auto battery system only. Do
not attempt to use it in any other system.
Doing so could cause serious damage.
Before you begin installation, look for the
following items which are packed with your unit.
≥ Warranty Card...Fill this out promptly.
≥ Panasonic Servicenter List for Service
Directory ...Keep for future reference in case
the unit needs servicing.
≥ Installation Hardware...Needed for in-dash
installation.
Qty No.
7
2 Rear Support Strap
8
1 Tapping Screw
(5 mm·k16 mm)
9
1 Mounting Bolt (5 mm·)
:
1 Power Connector
;
1 Removable Face Plate Case
<
1 Trim Plate
Item Diagram Qty
1
1
1
1
1
1