System Status Check - Panasonic WJ-SX650 Operating Instructions Manual

Terminal Duration
Alarm Output 1 to Until reset
32
Alarm Recover 100 or more ms
Input 1 to 16
Time Adjust 1 second
Output
Time Adjust Input 100 or more ms

■ System Status Check

During connection procedures, system status can be
checked on 4 monitors.
The following examples are procedures to display the sys-
tem status on Monitor 1 to 4.
● WV-CU950/650
1. Select one of Monitor 1 to 4. (Refer to p. 21 Monitor
Selection.)
2. Press the MENU button repeatedly until "System Status"
appears on the LCD.
3. Press the F1 button. SYSTEM STATUS will be displayed
on Monitor 1 to 4.
Note: SYSTEM STATUS is displayed on a set of 4 monitors
(Monitor 5 to 8, Monitor 9 to 12...Monitor 29 to 32).
● WV-CU360C/CJ
1. Select one of Monitor 1 to 4. (Refer to p.
Selection.)
2. Press the OSD and SYS S buttons at a time. SYSTEM
STATUS will be displayed on Monitor 1 to 4.
Note: SYSTEM STATUS is displayed on a set of 4 monitors
(Monitor 5 to 8, Monitor 9 to 12...Monitor 29 to 32).
Display example of SYSTEM STATUS
Remarks
Open Collector
<Monitor 1>
output, 16 V,
100 mA maximum
Non-voltage make
contact output
Open Collector
output, 16 V,
100 mA maximum
Non-voltage make
contact input
<Monitor 4>
MON: Monitor number
LCN: Camera number or recorder number
MODE: Display mode of the monitor
• SETUP: System Setup
• HISTORY: Alarm History Display
KB: System controller or PC
OPE: User ID of the operator or timer event No.
PRI: Operator priority
Notes:
21 Monitor
LCN, MODE, KB and OPE parameters are highlighted
for monitors during the alarm mode status.
SYSTEM STATUS
MON LCN MODE
01 001
02 002
03 200
04 030
05 100 G08
06 SETUP
07 HISTORY
08 R16
LCN:LOGICAL CAMERA NUMBER
LCN and MODE parameters are highlighted for monitors
during the alarm ACK status.
SYSTEM STATUS
MON LCN MODE
25
26 075
27 105 T32
28 002 T01
29 301 G32
30 401 G32
31 501 G32
32 999
LCN:LOGICAL CAMERA NUMBER
• When SETUP MENU is displayed, "0" appears on
this area.
• During monitor lock, this area is highlighted.
• Even while SYSTEM STATUS is being displayed on
monitors, normal operations and alarm control are avail-
able. However, you cannot check the camera or record-
ed images because black screen is displayed. It is rec-
ommended to use these monitors only to check SYS-
TEM STATUS.
• Up to 100 records of SYSTEM STATUS are saved in the
system. These records can be transmitted between PC
and this unit. (Periodical transmission is also available.)
For transmission, perform the serial command settings
in "Communication" – "Serial Command" of WJ-SX650
Series Administrator Console.
• To transmit SYSTEM STATUS records from the PC, refer
to Serial (RS-232C) Connector Command Reference
(PDF file on the supplied CD-ROM).
KB OPE PRI
K1-1 123 01
03
/T001 99
PC 999 14
K1-4 5 00
K3-2 10 02
505 03
KB OPE PRI
PSD 48 02
/T128 60
K6-3 3 05
12345 10
12345 10
K8-4 12345 10
37