To Stop The Operation; For Timer Operation - Sanyo MLS-3751 Instruction Manual

How to Use

To stop the operation

1) Press the
•The product is in standby status.
2) Check the following points before opening the cover.
• Pressure is lowered to 0MPa.
• COVER LOCK lamp goes out.
When the COVER LOCK lamp is lit, the temperature or pressure
inside the chamber rises to make it impossible to pull the movable
handle toward you.sterilization objects, wear heat-resistant leather
gloves for prevention of scald.
To open the cover immediately
• Lower the pressure and temperature inside the chamber
forcibly in the procedure as follows:
If liquid boils over in liquid sterilization, clean the inside of
the chamber.
Inside of the chamber :
1) Press the
2) To stop the exhaust, press the
3) Check the following points before opening the cover.
• Pressure is lowered to 0MPa.
• COVER LOCK lamp goes out.
When the COVER LOCK lamp is lit, the temperature or pressure
inside the chamber rises to make it impossible to pull the
movable handle toward you.
The temperature inside the chamber is raised hot. When taking
out the sterilization objects, wear heat-resistant leather gloves for
prevention of scald.

For timer operation

The operation can be programmed up to at 23:59 of 7 days later from
the current date and time.
1) Press the
The lamp above the timer button lights up
and the timer lamp on the digital
display II lights up, and the current date
and time flicker.
2) Press the
and press the
• The figures change quickly when the
pressed.
• The time on the digital display I flickers.
23
Beep
button.
See page 25.
button while pressing the
button again.
CAUTION
button.
and buttons to set the operation starting day
button.
button.
or button is kept
Lamp goes out.