Adjustment, Replacement And Assembly Of Mechanical Units - Sharp 27DV-S100 Service Manual

ADJUSTMENT, REPLACEMENT AND ASSEMBLY OF
MECHANICAL UNITS
The explanation given below relates to the on-site general service (field service) but it does not relates to the adjustment
and replacement which need high-grade equipment, jigs and skill. For example, the drum assembling, replacement
and adjustment service must be performed by the person who have finished the technical courses.
MECHANISM CONFIRMATION ADJUSTMENT JIG
So as to perform completely the mechanism adjustment prepare the following special jigs. So as to maintain the initial
performance of the machine the maintenance and check are necessary. Utmost care must be taken so that the tape is
not damaged. If adjustment needs any jig, be sure to sue the required jig.
1. Torque Cassette Meter
2. Torque Gauge
3. Torque Gauge Head
4. Torque Driver
Master Plane Jig and
5. Reel Disk Height
Adjusting Jig
6. Tension Gauge
Pinch pressing force
7.
measuring jig
Hex Wrench (1.2mm)
8.
Hex Wrench (1.5mm)
Reverse guide height
9.
adjusting box driver
JiGVHT-063 CZ
JiGTG0090 CM
JiGTG1200 CN
JiGTH0006 AW
JiGTD1200 CB
JiGRH0002 BR
JiGMP0001 BY
JiGSG2000 BS
JiGSG0300 BF
JiGTDP003 BK
JiGHW0012 AE
JiGHW015 AE
JiGDRiVER11055 AR
This cassette torque meter is used
for checking and adjusting the
torque of take-up for measuring
tape back tension.
These Jigs are used for checking
and adjusting the torque of take-
up and supply reel disks.
When fixing an y part to the
threaded hole using resin with
screw, use the jig. (Specified torque
5 kg)
These Jigs are used for checking
and adjusting the reel disk height.
There are two gauges used for the
tension measurements, 300 g and
2.o kg.
This Jig is used with the tension
gauge. Rotary transformer clear-
ance adjusting jig.
This Jigs are used for loosening or
tightening special hexagon type
screws.
This Jig is used for height adjust-
ment of the reverse guide (for
reverse guide height adjustment).
25
27DV-S100
27DV-CS10