Compatibility Information; Command And Hardware Compatibility; Ipv6 Basics Configuration Task List - HP FlexNetwork MSR2003 Configuration Manual

Compatibility information

Command and hardware compatibility

Commands and descriptions for centralized devices apply to the following routers:
•
MSR1002-4/1003-8S.
•
MSR2003.
•
MSR2004-24/2004-48.
•
MSR3012/3024/3044/3064.
•
MSR954(JH296A/JH297A/JH298A/JH299A)
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

IPv6 basics configuration task list

Tasks at a glance
(Required.)
•
Configuring an IPv6 global unicast address
•
Configuring an IPv6 link-local address
•
Configuring an IPv6 anycast address
(Optional.) Configuring IPv6
•
Configuring a static neighbor entry
•
Setting the maximum number of dynamic neighbor entries
•
Setting the aging timer for ND entries in stale state
•
Minimizing link-local ND entries
•
Setting the hop limit
•
Configuring parameters for RA messages
•
Configuring the maximum number of attempts to send an NS message for DAD
•
Enabling ND proxy
•
Configuring IPv6 ND suppression
•
Configuring IPv6 ND direct route advertisement
(Optional.) Configuring path MTU
•
Configuring the interface MTU
•
Configuring a static path MTU for an IPv6 address
•
Configuring the aging time for dynamic path MTUs
(Optional.) Controlling sending ICMPv6
•
Configuring the rate limit for ICMPv6 error messages
•
Enabling replying to multicast echo requests
•
Enabling sending ICMPv6 destination unreachable messages
•
Enabling sending ICMPv6 time exceeded messages
•
Enabling sending ICMPv6 redirect messages
•
Specifying the source address for ICMPv6 packets
(Optional.) Enabling IPv6 local fragment reassembly
(Optional.) Configuring IPv6 load sharing based on bandwidth
Assigning IPv6 addresses to
ND:
discovery:
interfaces:
messages:
210