HP FlexNetwork MSR2003 Configuration Manual page 410

[PrimaryServer-vam-server-domain-abc-hub-group-2] spoke ipv6 private-address
network 192:168:2::0 64
[PrimaryServer-vam-server-domain-abc-hub-group-2] quit
# Set the pre-shared key to 123456.
[PrimaryServer-vam-server-domain-abc] pre-shared-key simple 123456
# Set the authentication mode to CHAP.
[PrimaryServer-vam-server-domain-abc] authentication-method chap
# Enable the VAM server for the ADVPN domain.
[PrimaryServer-vam-server-domain-abc] server enable
[PrimaryServer-vam-server-domain-abc] quit
Configuring the secondary VAM server
# Configure the secondary VAM server in the same way that the primary server is configured.
(Details not shown.)
Configuring Hub 1
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure the VAM client:
# Create VAM client Hub1Group0.
<Hub1> system-view
[Hub1] vam client name Hub1Group0
# Specify ADVPN domain abc for the VAM client.
[Hub1-vam-client-Hub1Group0] advpn-domain abc
# Set the pre-shared key to 123456.
[Hub1-vam-client-Hub1Group0] pre-shared-key simple 123456
# Set both the username and password to hub1.
[Hub1-vam-client-Hub1Group0] user hub1 password simple hub1
# Specify the primary and secondary VAM servers.
[Hub1-vam-client-Hub1Group0] server primary ipv6-address 1::11
[Hub1-vam-client-Hub1Group0] server secondary ipv6-address 1::12
# Enable the VAM client.
[Hub1-vam-client-Hub1Group0] client enable
[Hub1-vam-client-Hub1Group0] quit
# Create VAM client Hub1Group1.
[Hub1] vam client name Hub1Group1
# Specify ADVPN domain abc for the VAM client.
[Hub1-vam-client-Hub1Group1] advpn-domain abc
# Set the pre-shared key to 123456.
[Hub1-vam-client-Hub1Group1] pre-shared-key simple 123456
# Set both the username and password to hub1.
[Hub1-vam-client-Hub1Group1] user hub1 password simple hub1
# Specify the primary and secondary VAM servers.
[Hub1-vam-client-Hub1Group1] server primary ipv6-address 1::11
[Hub1-vam-client-Hub1Group1] server secondary ipv6-address 1::12
# Enable the VAM client.
[Hub1-vam-client-Hub1Group1] client enable
[Hub1-vam-client-Hub1Group1] quit
3. Configure an IPsec profile:
396