Wan Commands - Motorola nvg589 Administrator's Hanbook

Administrator's Handbook
show voip
Displays VoIP call statistics.
show voiplog
Displays VoIP event logs.
telnet [ hostname | ip_address ] [ port ]
Lets you open a telnet connection to the specified host through your Motorola Gateway.
◆
The hostname argument is the name of the device to which you want to connect; for example,
ftp.Motorola.com
◆
The ip_address
connect.
◆
The port argument is the number of t he port over which you want to open a telnet session.
traceroute ( ip_address | hostname )
Traces the routing path to an IP destination.
upload [ server_address ] [ filename ] [ confirm ]
Copies the current configuration settings of the Gateway to a TFTP (Trivial File Transfer Protocol) server. The
TFTP server must be accessible on your Ethernet network. The
address of the TFTP server on which you want to store the Motorola Gateway settings. The
ment identifies the path and name of the configuration file on the TFTP server. If you include the optional
firm
keyword, you will not be prompted to confirm whether or not you want to perform the operation.
view config
Dumps the Motorola Gateway's configuration just as the
who
Displays the names of the current shell and PPP users.

WAN Commands

atmping vccn [ segment | end-to-end ]
Lets you check the ATM connection reachability and network connectivity. This command sends five Operations,
Administration, and Maintenance (OAM) loopback calls to the specified vpi/vci destination. There is a five second
total timeout interval.
Use the segment argument to ping a neighbor switch.
Use the end-to-end argument to ping a remote end node.
reset dhcp client release [ vcc-id ]
Releases the DHCP lease the Motorola Gateway is currently using to acquire the IP settings for the specified DSL
vcc-id
port. The identifier is an "index" letter in the range B-I, and does not directly map to the VCC in use.
reset dhcp client release
Enter the
each virtual circuit.
116
.
argument is the IP address, in dotted decimal notation, of the device to which you want to
server_address
view
command does in config mode.
command without the variable to see the letter assigned to
telnet
argument identifies the IP
filename argu-
con-