Mitsubishi Electric AG-150A Instruction Book page 18

Function
5 Fan speed Use the Up/Down
arrows below "Fan
Speed" to set the fan
speed.
6 Remote Prohibit Press the button that
controller corresponds to the
desired function and
setting to permit or
prohibit the operation
from the remote
controller. The functions
that can be prohibited
are as follows: ON/OFF,
operation mode,
temperature, and filter
sign reset.
7 Filter sign reset Press "Reset" under
"Filter Sign".
8 Ventilation ON/ Select the ON/OFF
OFF status for the interlocked
unit.
9 Ventilation Fan Set the fan speed with
speed the Up/Down arrows
below "Fan Speed".
10 OK Press the OK button to
reflect the change.
11 Cancel Press the Cancel button
to cancel the change.
Operation method
4-speed model:
("Auto" is not available on some models. Some models of units have only two or
three fan speeds.)
Pressing of each button toggles through the following three options:
Retention of current status → Permit → Prohibit
Operation mode
Filter sign reset
Filter cleaning warning sign will be cleared. (Cumulative operation time is reset.)
An orange frame will appear around the selected operation status.
2-speed model:
(Fan speed setting is not available on some models.)
Pressing the OK button saves the setting and takes the screen back to the previous
screen (Floor layout or Block display).
Pressing the Cancel button cancels the change and takes the screen back to the
previous screen (Floor layout or Block display).
(Low)
(Auto)
Retention of
current status
ON/OFF
Temperature
setting
(Low)
– 16 –
Display
(Mid 2) (Mid 1)
Permit
(High)
(High)
Prohibit