Advertisement
Mounting MP5 on the Roll Stand
The MP5 monitor will be equipped with one of two different mounting interfaces on the bottom of the monitor. The type of
interface determines which mounting procedure to follow on this page.
Mounting MP5 on Philips Table Top Mount (Requires Philips-supplied Table Top Mount)
1. Fasten the Philips-supplied table top mount to the Mounting Adapter with three (3) M6 x 10mm FHMS as shown below
left. Mount the monitor in accordance with Philips mounting instructions.
Fixed Tilt Mount
Mounting MP5 with Non-Table Top Mounting Adapter
1. Using a Phillips screwdriver, fasten monitor to Fixed
Tilt Mount with two (2) M6 x 8 mm PHMS as shown.
M6 x 10mm FHMS (3)
Philips-Supplied
Table Top Mount
Fixed Tilt Mount
M6 x 8mm PHMS (2)
DU-PH-0062-60 Rev A 7/16/07 GCX Corp Page 5 of 7
Mounting Adapter
Advertisement
